RB Scott: Equipment, Wear Parts, Service

Connect With Us Facebook

Your process equipment and wear parts specialists

Used GreyHawk/McLanahan UFR Plant, Unit #704

#1087

On Lease
    McLanahan Dewatering Screen One (1) Model VD-12 (4'x 10') LPT Dewatering Screen, each complete with:
  • Two 4.5HP vibratory motors Heat treated motor bridge Huck bolted construction Modular polyurethane screen media
  • Rubber vibration isolation buffers
  • Discharge Chute with ¼”
  • UHMW liner   McLanahan Hydrocyclones Three (3) Model HSE1210 LPT HydroCyclone: Fabricated steel with bonded rubber linings 10 degree cone Feed Box extension Polyurethane vortex finder Apex with drop-in rubber liner Apex splash guard - reinforced rubber sleeve SDR-11 overflow pipe with flanges Pressure gauge port - ½”
  • NPT Manifold Three-Way SDR-11 Feed Distributor with: Inlet diameter - 8" Outlets - 
  • Three (3) x 4" Standard ANSI 150lb flanged connections Slurry Pump 8" x 6" LPTpump™
  • Slurry Pump Field replaceable molded rubber casing liners Molded rubber impeller with internal steel
  • skeleton Type ‘D’ gland Grease lubricated bearings Overhead motor table  
  • Drive package consisting of: Motor - 75HP, 1800 RPM, 460 volt, 3-phase, 60 cycle, TEFC, inverter duty V-belt drive sheaves & belts Drive guard   Chassis:  
  • (2) axles with (8) 11-22.5 radial tires on

Budd wheels 18” x 46# wide flange main frame beams (6) 18” x 46# welded blocking support legs 2900 gallon ¼” steel slurry tank supported with 4” beams and reinforced gussets including 10” inlet pipe with ANSI flange and 16” output pipe with flange Tank includes hinged door, for self balancing Fifth wheel Assembly with “Tilt-Away” feature to provide easy access for a loader to the sand stockpile. ¼” steel reinforced sand barrier across the front cribbing legs Slurry pump support frame Air controlled brakes Light bar Mud flaps Diamond Plate walkway on both sides of screen of the chassis Walkways include handrail, center rail, and toe board Access ladders on both sides of carrier   Hydrocyclone Support Assembly Fabricated steel support mounting structure for the hydro-cyclones and SDR-11 manifold and overflow piping.  This bolt-on H-beam and tubular structure can be lowered for travel and the entire assembly is removable for travel or maintenance.   Hydraulic Package Six - 37,000 lbs 4" diameter x 18" stroke leveling cylinders to lift the plant into the operating position.

Each cylinder is independently controlled from a hydraulic valve for precise control and ease of leveling. Two 3” x 16” cylinders for raise and lower of the Hydrocyclone assembly. Power Fold King Pin Assembly with two 4” x 16” cylinders for the raise and lower of the king pin assembly. The hydraulic system is powered by an 11 HP Honda gasoline engine with electric start and backup recoil start, mounted in a fabricated assembly with a lockable lid.   Electrical: Complete electrical wiring, starters and controls.   Safety Guards: We install all standard guarding, customer will be responsible for compliance with local codes   General: Chassis to be sandblasted, two part epoxy primer painted one coat and two part urethane finish painted one coatGreyHawk beige with orange highlight stripe on the trailer frame beams. (2) sets of owners/parts manuals